The CT224 consists of a 12-Channel Temperature Monitor and MincoSoft™ CT224 Software. It is the next generation in temperature monitoring equipment from Minco designed to meet the needs of electric machinery protection.The 12-channel scanning capability, standard RS485/RS232 interface andWindows-compatible software utility for system configuration and data logging provide overtemperature and undertemperature protection and critical feedback to safeguard expensive machinery.

UL and cUL recognized to
help meet regulatory
compliance

Mix and match sensor input
types for freedom to adapt
to pre-installed bearing and
apparatus sensors

Ability to monitor 12 inputs
allows you to monitor stator
sensors from two motors

Model S3238 Thermal-Ribbon is designed to sense stator temperatures in motors and generators.With an alternative installation method to the “stick-type” sensors in this section, S3238 is used on the end turns of stator windings and provides an easy way to add overtemperature protection when the stator is not being rewound.

Alarm shuts down motor on over-temperature to prevent
catastrophic failure

Monitors single 100 Ω platinum RTD (PD or PE)

1 or 2 relays with independent trip points for warning
and shutdown

Microprocessor-based

Front panel programmable with four security levels

100 to 240 VAC supply power

Compact
DIN case with water resistant front panel

Flexible silicone rubber insulation

Mount on windings or housings to prevent moisture
buildup

2.5 to 10 watts per square inch at 120 or 240 volts

Variety of sizes to 60” (1.5 m)

UL component recognition

Available from stock