|
Models 101, 102, & 103 Designed for a wide range of applications where a simple mounting scheme is required. | Model 101 is a Straight Sheath temperature sensor.
• Refer to Model 201 if welded fitting is required.
• Refer to 300 Series if spring loading is required.Model 102 is a Copper Tip Sensitive temperature sensor.
• Refer to Model 303 or 304 if spring loading is required.Model 103 is a Reduced Tip/Fast Response temperature
sensor.
• Refer to Model 203 if welded fitting is required. |
Specifications:
1. Model
| Base Model/Series Number. | | 2. A. Accuracy: B. TCR:
C. Ice Point Resistance:
D. Response Time:
E. Tip Sensitivity: | Standard Class B (no code)
High Class A (code H)
Special Customer Specified (code S)
* Industry Standard is DIN Curve (code 01B), Platinum, 100 ohms @ 0°C. Conforms to IEC 751, DIN 60751.
Temperature Coefficient of Resistance is the temperature vs. resistance characteristics of a given metal
(Pt, Cu & Ni) used in manufacturing the RTD. Determines the curve of the RTD.
Ro - Resistance at 0°C (32°F) Dependent on sheath diameter, the smaller the diameter - the faster the response. See RTD General Specs. Model 102 Copper Tip, element is encapsulated in copper to increase sensitivity at tip of probe. | 3. Construction:
| Code A - 316SS tube and wire construction, thin film element (.00385055) TCR, Teflon insulated lead wire. Code C - 316SS tube and wire construction, wire wound element, fiberglass insulated lead wire. Code B & D - Inconel sheathed MgO construction, wire wound element, fiberglass insulated lead wire. | 4. Lead Wires:
|  | 5. Sheath Diameter:
| .250” (1/4”) is the industry standard. Code C/N for reduced tip design. | 6. Sheath Length:
| Entire stem length. | 7. Lead Wire Length:
| Length of wires beyond the sheath. Use Z000 if connector is installed directly on the end of sheath. | 8. Lead Wire Protection:
| Stainless Steel Overbraid or Stainless Steel Armor. Order length at 3”-6” shorter than lead wire length.
Example: Z024-X020 | 9. Connectors:
| Optional male plug for sensor end. For mating jack add code “/J”. | 10.Optional Fittings:
| Sensor is not supplied with mounting hardware, specify optional fitting. | | 11.Water resistant: | Increases moisture protection for humid environments. |
 |
|
|
|
|
<< Start < Prev 1 2 3 4 5 Next > End >>
|
|
Page 1 of 5 |
